Replacement Brush for Electrostatic Carpet Sweeper

Make Your Sweeper Like New Again

This is a replacement natural horsehair roller brush for the Fuller Brush and Stanley Electrostatic Carpet & Floor Sweepers. It's the same brush that comes with every new sweeper.

Horsehair bristles are soft and flexible, but they hold up well and last a long time. Swap in a fresh brush when the old one is worn out and your sweeper will pick up like new.

Best For

• Low-pile rugs and carpet
• Smooth hard floors

How to Remove and Replace the Brush

1. Turn the sweeper upside down on a firm, flat surface. The brush (horsehair or vinyl) sits in the middle of the sweeper.
2. Each end of the brush has a drive wheel with a small knob sticking out. Each side of the sweeper has a plastic tab with a metal ring (grommet). The knobs fit inside these rings.
3. To remove: push one tab outward while pushing the brush toward the opposite side. The knob will slide out of the ring and you can lift the brush out.
4. To install: place the knob on one end of the new brush into one of the rings. Push the opposite tab outward and lower the other knob into that ring. Let go of the tab and the brush will snap into place.

Prefer to watch? Watch the how-to video in the product photos at the top of this page. Look for the image with the ▶ play button.

Will It Fit My Sweeper?

This brush fits Fuller Brush and Stanley sweepers made in the past 8 years. The Fuller Brush and Stanley sweepers are exactly the same except for the brand name, so it fits both.

It will NOT fit older models.

Product Details

• Bristles: natural horsehair
• Size: 8.5 x 1.5 x 1.5 inches
• Fits: Fuller Brush and Stanley Electrostatic Carpet & Floor Sweepers made in the past 8 years
• Made: made in China

Please note: The roller brush only fits recent Electrostatic sweepers 17027,17052,17028,17029,17072,17032,17031, and 17042. It will not fit older model sweepers.

How to Remove and Replace the Brush
1. Turn the sweeper upside down on a firm, flat surface. The brush (horsehair or vinyl) sits in the middle of the sweeper.
2. Each end of the brush has a drive wheel with a small knob sticking out. Each side of the sweeper has a plastic tab with a metal ring (grommet). The knobs fit inside these rings.
3. To remove: push one tab outward while pushing the brush toward the opposite side. The knob will slide out of the ring and you can lift the brush out.
4. To install: place the knob on one end of the new brush into one of the rings. Push the opposite tab outward and lower the other knob into that ring. Let go of the tab and the brush will snap into place.
Prefer to watch? Watch the how-to video in the product photos at the top of this page. Look for the image with the play button.